Sakai SW800-II, Shop Manual

Page: 227 / 258

10-053
TROUBLESHOOTING
2-6-1. Continuous water spray does not operate 2/2
Water spray selector switch must be CONT.
Set water spray pump switch to simultaneous spray position.
Water spray timer must be OFF.
Reference Fig.: 2-6-1
Check point Check/Cause Action
4. Water Spray Selector
Switch
(1) When starter switch is ON, measure voltage between
water spray selector switch terminal 1 inlet wire WB and
chassis ground.
Standard voltage: 12 V or more
(2) When starter switch is ON, measure voltage between
water spray selector switch terminal 2 outlet wire GB
and chassis ground.
Standard voltage: 12 V or more
If above item (1) is OK and item (2) is NG, water spray
selector switch is faulty.
•
Replace water spray
selector switch.
5. Harness Connecting
Between Terminals
Measure resistance of harness connecting between
terminals.
Standard resistance: 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.
•
•
•