Sakai SW800-II, Shop Manual

Page: 199 / 258

10-025
TROUBLESHOOTING
2-3-5. Glow plug is not heated (Engine starting performance is bad in cold weather)
Reference Fig.: 2-3-1
Check point Check/Cause Action
1. Glow Plug When starter switch is START, measure voltage between
glow plug inlet wire and chassis ground.
Standard voltage: 12 V or more
If measurement is within standard range, glow plug is
faulty.
•
•
Replace glow plug.
2. Switch Relay (1) When starter switch is START, measure voltage
between switch relay terminals 1, 2 and 3 and chassis
ground.
Standard voltage: 12 V or more
(2) When starter switch is START, measure voltage
between switch relay terminal 5 wire and chassis
ground.
Standard voltage: 12 V or more
If above item (1) is OK and item (2) is NG, switch relay or
EMR 3 is faulty.
•
Replace switch relay.
2-3-6. Starter motor runs even when F-R lever is not at neutral position
Reference Fig.: 2-3-1
Check point Check/Cause Action
1. F-R Lever Switch When shifting F-R lever to forward or reverse position with
starter switch OFF, check continuity between F-R lever
switch terminal COM and terminal NC.
Switch is OK if there is no continuity.
If there is continuity, F-R lever switch is faulty.
•
•
Replace F-R lever
switch.