Sakai SW800-II, Shop Manual

Page: 189 / 258

10-015
TROUBLESHOOTING
Blink code
Description
Short (0.4 sec.) Long (0.8 sec.) Short (0.4 sec.)
5 2 7 CAN message, missing (message “FuncModCtl”= function
mode control).
•
5 2 8 Engine brake (internal), cable break or short circuit. •
5 3 1 Begin of injection period, outside target range or missing
(cylinder 1).
•
5 3 2 Begin of injection period, outside target range or missing
(cylinder 2).
•
5 3 3 Begin of injection period, outside target range or missing
(cylinder 3).
•
5 3 4 Begin of injection period, outside target range or missing
(cylinder 4).
•
5 3 5 Begin of injection period, outside target range or missing
(cylinder 5).
•
5 3 6 Begin of injection period, outside target range or missing
(cylinder 6).
•
5 3 7 Begin of injection period, outside target range or missing
(cylinder 7).
•
5 3 8 Begin of injection period, outside target range or missing
(cylinder 8).
•
5 5 5 Engine power output, cable break or short circuit.
Rail pressure, rail-pressure monitoring is going to be
disabled.
ECU internal error, communication with chip CJ940
disturbed, time processing unit defective or serial
communication interface defective.
ECU internal hardware monitoring, recovery occurred
(stored as protected, not stored or error memory),
overvoltage or undervoltage.
•
•
•
•
(NOTICE)
For details, refer to “Troubleshooting” in Shop Manual of engine manufacturer. •