6- Advanced parameters
Page 6-26
F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
Field
Action
Default
value
PPP MTU (Bytes)
Enter an MTU (
M
aximum
T
ransfer
U
nit) value. This value (in
bytes) is between 38 and 1492.
Note:
The MTU specifies the maximum size of the data used
(IP packets) expressed as a number of bytes.
1492
Use Static IPv4 Address
Check the box to use the static IPv4 address.
Not
checked
IPv4 Address
b
Enter the static IPv4 address.
0.0.0.0
Enable PPP Debug
mode
Check the box to use the PPP Debug mode.
In the event of connection failure, this option will enable you to
trace a possible problem in the SYSLOG file.
Not
checked
Bridge PPPoE frames
between WAN and Local
Ports
Check the box to enable the router when bridging the frames
between WAN and local Ethernet ports.
Not
checked
Enable IGMP Multicast
Proxy
Check the box to activate the IGMP function.
Not
checked
No Multicast VLAN
Filter
Check the box to disable Multicast VLAN Filter.
Not
checked
a. This field only appears when the "PPP retry on authentication error" field is activated (box checked).
b. This field only appears when the "Use Static IPv4 Address" field is activated (box checked).
•
Click on the
Next
button to continue configuring the remote network (WAN) in PPPoE mode.
•
Select a preferred WAN interface as the system default gateway.
Summary of Contents for F@ST 2704R
Page 1: ...F ST 2704R Reference Manual...
Page 2: ......
