F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
Page A-7
A- Annex A - Troubleshooting
A.6 Restarting your router
We recommend that you restart your router if you notice that the router does not operate properly.
To restart your router, use one of the following methods:
•
Press the
Power
button located on the rear panel of the router. Press it again to switch it back on.
•
Click on the
Reboot
action of the HTTP configuration tool.
During restarting, the status of the LEDs is the following:
The
LED will light up first, followed by the four Ethernet LEDs (1 to 4), then these last four LEDs will be
off. The
and Ethernet (which corresponds to the connected interface) LEDs should be steady and the
LED blinks during the establishment of the ADSL link, then steadies like the
LED. The
goes from
blinking to steady when a PPP session has been created successfully.
Note
The powering up process lasts around one minute.
A.7 Resetting factory configuration
If you lose your password or if, after having entered new parameters in your router, you cannot access the
Internet nor the HTTP configuration tool, you can restore the normal operation with the "factory" parameters
via the
Restore Default
procedure.
When the procedure is finished you will have to enter again your connection ID and connection password
delivered by your Internet Service Provider (see
Internet Connection
- section 5.5.2.1)
To reset the default settings and therefore restore the router to its factory configuration, use one of the
following methods:
Important
This operation deletes the entire personalised configuration of your router:
Password, Configuration, customized wireless settings, etc.
After a factory configuration reset, it is
necessary to install your router again
using the installation CD-ROM, or to enter again the ADSL connection data
supplied by your
I
nternet
S
ervice
P
rovider (ISP) (see Internet Connection
section 5.5.2.1).
•
Press and hold for about 10 seconds the
Reset
button located on the rear panel of the router.
•
In the HTTP configuration tool, select
Management > Settings > Restore default
.
Summary of Contents for F@ST 2704R
Page 1: ...F ST 2704R Reference Manual...
Page 2: ......
