6- Advanced parameters
Page 6-52
F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
Proceed as follows:
•
Select the required WAN interface in the
Use Interface
list.
•
Check the
Select a Service
box, then select the service of your choice from the scroll down list, for
example "SNMP".
The
External Port Start
,
External Port End
,
Internal Port Start
,
Internal Port End
and
Protocol
fields (transport protocol associated with this service) are automatically filled in the table.
Note
or
You may complete the table by adding other ports associated with a protocol.
•
Check the
Custom Service
box, enter the name of the server you want to connect to, then:
-
Complete the ID Host of your computer's IP address (this is attributed by your router's DHCP
server).
-
Fill in the
External Port Start
,
External Port End
,
Internal Port Start
,
Internal Port End
and
Protocol
fields.
A few rules for entering values:
•
When you want to select a single port, the start port (
External Port Start
or
Internal Port Start
) and the
end port (
External Port End
or
Internal Port End
) must be identical.
•
When you want to select a range of ports, the start port number must be lower than the end port number.
•
You must always start entering with the
External Port Start
and
External Port End
ports.
•
When you allocate a number to an
External Port Start
, the same number is automatically allocated to
the
Internal Port Start
and identically for
External Port End
.
The following diagram contains an example:
The "Delta Force 2" service is available on your computer via the external ports 3568 and 3569 (WAN side)
and via the internal ports 3568 and 3569 (LAN side).
Summary of Contents for F@ST 2704R
Page 1: ...F ST 2704R Reference Manual...
Page 2: ......
