3-49
Using the Operator Panel
• Deleting data
• Printing a list of data names (partitions)
The operations of the RAM disk are the same as those of the memory card. See the
relevant sections in “Using the Memory Card”, page 42. When data is written to the
RAM disk, the name automatically given to the corresponding file will be DataH001
(for the 1st file), DataH002 (for the 2nd file), DataH003 (for the 3rd file), etc.
Note :
The RAM disk can not be used when an optional hard disk is installed.
The RAM disk stores data only temporarily. When the printer is reset or turned off,
the stored data will be erased.
The RAM disk is allocated within the printer's memory available to users. If the size
of the RAM disk is set too large, the printing speed may decrease or the memory may
become insufficient.
Setting the RAM Disk Size
Press
[MENU]
.
Press
or
repeatedly until
RAM Disk Mode
appears.
Press
[OK]
. A blinking question mark (?) appears. Press
or
to select On.
Press
[OK]
.
Press
. Press
or
repeatedly until
>RAM Disk Size
appears. The data
size also appears.
Press
[OK]
. A blinking cursor (_) appears. Press
or
to display the
desired size. Definable RAM disk size is 0001 to 1024.
This range varies depending on the total memory size of the printer. The
setting exceeding this range is automatically adjusted to the maximum RAM
disk size.
When the desired RAM disk size is displayed, press
[OK]
.
Press
[MENU]
. The display returns to Ready. Turn the printer off and then on
again. The selected RAM disk size is activated after the printer is restarted.
LU 252 745 005 Fonctions d'impression HFF GB.book Page 49 Mercredi, 7. juin 2006 4:56 16
