MorphoAccess® SIGMA Series - Administrator Guide
Terminal Configuration through Webserver
2017_2000025464-v03
This document and the information therein are the property of Morpho. They must not
be copied or communicated to a third party without the prior authorization of Morpho
319
July 17
a.
Set Finger Biometric as ON, if an administrator wants to allow user to access by
fingerprint identification. If trigger event through biometric is OFF, then user
cannot initiate the access rights check using fingerprint. And Biometric Check will
be bypass for the particular user.
NOTE: In case the MorphoAccess® SIGMA Family terminal is used in Legacy L1
mode, a generic user rule is required to be set as authentication using Card
Only. Which can be set from access path Biometric Security > Trigger event.
And biometric check of the users, except the ones whose biometric check is
bypass, is required to be enabled using specific user rule configuration.
b.
Set Contactless Card as ON, if an administrator wants to allow user to request
access by presenting card authentication
c.
Set Keypad as ON, if an administrator wants to allow user to request access by
entering User ID using keypad. The authentication is done by matching the User
ID of the stored user in the database.
d.
Set External Port as ON, if an administrator allows a user to request access by
providing his User ID through External port
20.
Under Reference Check, an administrator can configure whether user’s information
should be referred from Terminal database or/and Smart Card
a.
Set Terminal as ON, if terminal should refer to user’s profile in database
b.
Set Smart Card as ON, if terminal should refer to user’s profile in smart card
Figure 300:
Defining User Rule – Control Check
21.
Under Control Check, an administrator can set:
a.
PIN mode as ON, if PIN based authentication is required
b.
Finger Biometric as ON, if Biometric authentication is required
c.
Face Auth Rule, … (to be completed)