MorphoAccess® SIGMA Family Administrator Guide
MorphoAccess® Terminal Administration Menu
2017_2000025464-v03
This document and the information therein are the property of Morpho. They must not
be copied or communicated to a third party without the prior authorization of Morpho
206
July 17
Screens & Steps
Figure 186:
Configuring the events on which authentication/identification is triggered
1.
Select the events listed in the trigger event screen (above) as ON or OFF
2.
Use Check button “
” to save settings
Set Duress Mode
The administrator can enable Duress Mode in MorphoAccess® SIGMA Family terminal by using
this parameter. The administrator can allow capturing of a user’s duress finger in addition to
two normal fingers, by setting the Duress Mode.
On detection of a Duress finger, the terminal will send a “Duress Finger Event” to the controller
using a communication channel such as IP channels, Wiegand, Clock and Data, RS485/RS422 or
TTL outputs.
MMI is played when the Duress finger is successfully authenticated. An MMI for duress finger
event is similar to normal finger event on access granted. Refer to “