90
CFIP PhoeniX C Series TDM/IP Split Mount System Technical Description and Configuration Guide
•
Rev. 1.0
•
© SAF Tehnika JSC 2013
Figure 67: Static route and NAT setting
Each static route and/or NAT record must be entered separately. The same confirmation window as for
IP address configuration appears after each record input erase. The Continue button should be
pressed for proceeding with any other IP settings. The button Write And Apply should be selected for
applying all IP settings to running system after last record input (when other IP configuration is not
required).
The description of particular setting and display boxes – Static Routes
–
Routed IP / MASK –
The IP address from routed network and the appropriate network mask
must be entered. Routed network range is calculated from entered values.
–
Gateway IP –
The correct IP address gateway for above network must be entered.
The ADD button is used for entering new route into the routing table, the DELETE button for deleting
record from the routing table.
NOTE:
It is not required to fill in the Gateway IP address when record from the routing table should
be deleted.
The description of particular setting and display boxes – NAT changes
–
LocalPort DestIP:Port –
The NAT record must be entered in the form of following command:
-
local_port destination_ip: port
local_port
– The number of a port on local IP which is used for address translation, it
must be followed with space character.
d
estination_ip
– IP address of destination/remote unit.
port
– Port number of service at destination/remote IP.
Example: 1080 192.168.4.101:80
