Runco D-73d Ultra, Installation & Operation Manual

Page: 107 / 152

Operation
D-73d Series Installation/Operation Manual 91
Remote Control: Select Remote Control from the Service menu to set the following
options:
• Remote Code: Select Remote Code from the Remote Control menu to set the
infrared (IR) custom code (address) that the Dimension Digital Controller will accept
as valid IR data. By default, it is set to 08209 (0x2011). You can change this setting
if:
• Another device in the theater (a DVD player, for example) is responding to
commands from the Dimension Digital Controller remote control (Figure 2-6) in
ways that are unpredictable or undesirable; or
• You have multiple Dimension Digital Controllers and want to control them
independently, as opposed to broadcasting commands from a single remote to all
of them. In this scenario, you can use multiple remotes programmed to use
different IR codes. Or, you can use a single remote and change the IR code as
needed to address a specific Dimension Digital Controller.
After changing the Remote Code, press EXIT to have the new code take effect.
When you change the Remote Code on the Dimension Digital Controller, you must
re-program the Dimension Digital Controller remote control to send that same code.
To enable “extended” key code mode, you must re-program the Dimension Digital
Controller remote control with a special five-digit code reserved for that purpose.
To do this:
1. Press and hold the LIGHT button on the
remote control for approximately five
seconds, or until the LED on the remote lights
solid red.
2. Enter a new five-digit code between 00000
and 65535 inclusive;
— OR —
To enable extended key code mode, enter 88999 . This mode allows certain
buttons to perform alternate functions; refer to D-73d Remote Control Unit on
page 15. (To switch from extended mode back to standard mode, enter any valid
code other than 88999.)
Include leading zeros for codes with four or fewer digits; for example, enter 255
as
00255 .
3. The LED turns off to confirm the code change. If you enter an invalid code, the
LED flashes for three or four seconds. Try again, entering a valid code.
For more information on using standard and extended remote control key codes,
refer to
Using Discrete IR Codes on page 118.
Use the Dimension Digital Controller front-panel keypad to change
the IR code to which the controller will respond. Then, change the
code sent by the remote to match as described below.
Tip