Runco D-73d Ultra, Installation & Operation Manual

Page: 75 / 152

Installation
D-73d Series Installation/Operation Manual 59
Anamorphic Lens
Adjustment If you are installing a D-73d with anamorphic lenses, proceed as follows to adjust them.
1. Select the Cinema aspect ratio using either the Dimension Digital Controller
remote control unit (see Figure 2-6) or the OSD menu (press MENU , then select
Aspect Ratio -> Cinema ). (With a D-73d/CineWide with AutoScope, this should
position the anamorphic lens transport in front of the primary lenses.)
2. On the Dimension Digital Controller remote control or front panel, press MENU .
3. Select Calibration from the Main Menu.
4. Select Adjustment Mode from the Calibration Menu and set it to Primary .
5. Press EXIT (or MENU ) repeatedly to return to the Main Menu.
6. Select Service from the Main Menu.
7. Select Test Video from the Service Menu and choose Primary Alignment .
Adjusting the Left (Top) Anamorphic Lens: Align the primary (left-eye) image with
the screen by adjusting the Left (top) anamorphic lens to produce the least amount of
distortion.
• Horizontal Position (X-adjust): Loosen the Yaw/X-Adjustment Levers underneath
the lens holder. Then, slowly move the anamorphic lens into place so that there are
no shadows on either side of the screen:
When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Too Far Right
Too Far Left
Correct position