Runco D-73d Ultra, Installation & Operation Manual

Page: 106 / 152

Operation
90 D-73d Series Installation/Operation Manual
Press MENU to exit test pattern mode.
Input Names: You can give each input a descriptive name. For example, you may
want to change the default input name to the type of source component connected to it:
“VCR,” “DVD,” “Laptop” et cetera. Input names can be up to 12 characters long.
To edit an input name, select Input Names from the Service menu. Press or to
select an input and press
ENTER . Use the or buttons to change a character;
press or to select a character to change. When you have finished editing the input
name, press ENTER or MENU .
To restore the default input name, press repeatedly to highlight that input name in
the “Restore” column. Then, press ENTER .
3D
Use these patterns to confirm
that the left-eye and right eye
images are being processed
correctly. To do this, close your
right eye while viewing this test
pattern through the 3D glasses. If
you see only the left-eye portion,
then the system is correctly
configured for 3D.
Normally, the Primary scaler
processes the left-eye image; the
Secondary, the right-eye image.
To change this, use the Reverse
Eyes control in the 3D
Processing menu (refer to
Reverse Eyes
on page 79).
Table 4-4. Test Patterns and Their Suggested Usage
Pattern Suggested Usage
Input Names
Restore
C o mp o s i t e 1
Composite 1
C o mp o s i t e 2 Composite 2
C o mp o s i t e 3 Composite 3
C o mp o n e n t
Component
H D 1
HD 1
H D 2 HD 2
S C A R T SCART
H D M I 1
HDMI 1
H D M I 2
HDMI 2
H D M I 3 HDMI 3
H D M I 4
HDMI 4
H D M I 5
HDMI 5
H D M I 6
HDMI 6
H D M I 7 HDMI 7
H D M I 8
HDMI 8
D i s p l a y P o r t
DisplayPort