Runco D-73d Ultra, Installation & Operation Manual

Page: 74 / 152

Installation
58 D-73d Series Installation/Operation Manual
D-73d/CineWide or D-73d/CineWide with AutoScope - Shasta Anamorphic Lens
Installation:
The D-73d “Shasta” Anamorphic lens mount kit consists of everything
shown in Figure 3-27.
Figure 3-27. Shasta Anamorphic Lens Mounting Assembly - Exploded View
1. Remove the two Yaw/X Adjustment Levers and Washers ( 7 ) from the bottom of the
Anamorphic Lens Holder ( 2 ).
2. Place the Anamorphic Lens Holder on top of (or under, if the projector is inverted)
the AutoScope Lens Motor Carriage Plate or CineWide Base Plate. Position the
bracket so that the slots at the bottom of the lens holder are perpendicular to the
corresponding slots on the base plate.
3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers ( 6 )
and Yaw/X Adjustment Levers that you removed in Step 1.
4. Use the 1/4-20 Button-head Screws ( 4 ) to attach the Anamorphic Lenses ( 1 ) to the
Anamorphic Lens Holder. Attach (but do not fully tighten) the 4-40 Set Screws ( 3 ).
To avoid clipping the corners of the image, position the
anamorphic lenses as close as possible to the primary lenses.
*Use included
L-wrench to tighten
Shasta Anamorphic
Lenses (2x)
Yaw/X-adjustment Lever
and Washer (2x)
Anamorphic Lens
Holder 2
1
4-40 Set Screw (4x)* 3
¼-20 Button-head
Height Adjustment
Screw (8x)*
5
¼-20 Button-head
Pitch Adjustment
Screw (4x)* 4
7
¼-20 Hex Bolt
and Washer (2x)
6
AutoScope Lens
Motor Carriage Plate
(shown here) or Fixed
CineWide Base Plate
Tip