Runco D-73d Ultra, Installation & Operation Manual

Page: 112 / 152

Operation
96 D-73d Series Installation/Operation Manual
• HPD Toggle Rejection: Select HPD Toggle Rejection from the HDMI menu to
specify whether or not the Dimension Digital Controller ignores extraneous Hot Plug
Detect (HPD) signal state changes from a downstream HDMI device (third-party
display or audio/video receiver).
The default setting, Auto , enables HPD toggle rejection on the D-73d. Use the other
settings to troubleshoot compatibility issues or reduce the amount of time needed to
lock to an incoming signal.
Front Panel Brightness: Select Front Panel Brightness from the Service menu to
adjust the brightness of the front-panel LED and LCD status indicators.
• Logo LED: Select Logo LED from the Front Panel Brightness menu to adjust the
brightness of the large, illuminated logo on the left side of the display. The range is
from 0 (off) to 31.
• Standby LED: Select Standby LED from the Front Panel Brightness menu to
change the behavior of the front-panel STANDBY indicator LED. When set to ON,
the LED lights amber when the system is in standby mode; otherwise, it is off. When
set to OFF, the LED is always off.
• LCD: Select LCD from the Front Panel Brightness menu to adjust the brightness of
the front-panel LCD. The range is from 0 (off) to 4.
Auto Power Off: Select Auto Power Off from the Service menu to have the D-73d turn
itself off after a period of inactivity (no source signal present).
• Enable: By default, Auto Power Off is set to No Signal . With this setting, the D-73d
powers off after a specified period of inactivity (no source signal present). To change
this behavior, select Enable from the Auto Power Off sub-menu. Then, set it to
On to
have the D-73d power off after the specified time period whether a source signal is
present or not. Or, set it to
Off to disable this feature altogether.
• Hours: Select Hours from the Auto Power Off sub-menu to specify the number of
hours after which the D-73d should power off. The default time-out period is one
hour; the range is from 1 to 24 hours.
The Dimension Digital Controller does not transmit HDMI CEC
control messages from the “HDMI Audio Out” connector,
regardless of the CEC setting.
During a firmware upgrade, this LED lights at full brightness
regardless of the Logo LED setting.
During a firmware upgrade, this LED lights at full brightness
regardless of the Standby LED setting.
Note
Logo LED
LCD
Standby LED
Note
Note