Operation
D-73d Series Installation/Operation Manual
87
Copy/Paste - Aspect Ratio:
You can also copy and paste certain settings, such as
those for Output Shift and Image Alignment (refer to page 87) from one aspect ratio or
“screen” (refer to
Screen
on page 70) to another.
To do this, select Copy/Paste from the Calibration menu, then select Aspect Ratio.
• Aspect Ratio - Copy Settings:
Select Copy Settings from the Copy/Paste Aspect
Ratio menu to place the Output Shift and Image Alignment settings for the current
aspect ratio onto a “clipboard,” which is a temporary memory location. When you do,
the message “Settings Copied” briefly appears on-screen. The Copy/Paste menu
then re-appears, indicating the source of the copied settings.
• Aspect Ratio - Paste Settings:
To apply the Output Shift and Image Alignment
settings on the clipboard to a different aspect ratio and/or screen, do
either
of the
following:
• Switch to another aspect ratio (for example, from 16:9 to Cinema).
• Switch from Screen 1 to Screen 2 or vice versa.
Then, select Paste Settings from the Copy/Paste Aspect Ratio menu. The new
settings are saved automatically.
Output Shift:
The Left/Right, Up/Down, Width and Height controls in the Output Shift
menu are similar to those in the Input Position menu, except that they change the
characteristics of the output signal. These settings are saved independently
for each
aspect ratio and screen selection
(refer to
Screen
on page 70).
• Screen Masking:
This control adjusts the amount of cropping on each edge of the
output image. This differs from the regular Overscan control in two ways:
• It allows separate adjustments on each edge; and
• It is saved per aspect ratio, per screen (as opposed to per connector, per mode).
This is useful for installations where the aspect ratio of the screen doesn’t exactly
match the aspect ratio of the display.
Image Alignment:
Use the controls in the Image Alignment menu to ensure that the
output images from the Primary and Secondary optical engines are perfectly
rectangular and aligned with each other. For detailed instructions, refer to
Adjusting
the Image Geometry
on page 62.
Adjustment Mode:
By default, any command or control message you send using the
remote control, front-panel keypad or RS-232 interface is acted upon by
both
the
Primary and Secondary scalers in the Dimension Digital Controller. In some cases —
for example, when aligning the output images from the two optical engines — you may
need to address a command to only the Primary or Secondary scaler (that is, adjust
only the “left eye” or “right eye” image). To do this, select Adjustment Mode from the
Calibration menu and set it to
Primary
or
Secondary
. The Main Menu title changes to
“Runco Video (Pri.)” or “Runco Video (Sec.)” when you do this.
Copy/Paste
Memory Preset
Aspect Ratio
Aspect Ratio
Copy Settings
Paste Settings
Copied From:
Aspect Ratio
16:9
Screen
Screen 1
Copied settings are not retained after a power cycle.
Note
Summary of Contents for D-73d Ultra
