Note:
and
representing entire-U delimiters
Before installing a guide rail, confirm that the weight capacity of the guide rail meets requirements.
RG-S12000 series switches have two models with different heights. Install the chassis in the cabinet
according to the actual situation.
Considering a variety of guide rails, guide rail appearance and installation methods depend on the actual
situation.
The RG-S12000 series switches are heavy. To ensure cabinet stability: install the guide rail to as low a
position as possible in the cabinet if one RG-S12000 is installed; install heavier devices in the lower part of
the cabinet if multiple devices are installed.
It is recommended to install the power socket after planning on available space properly. Otherwise, there
may be problems for operation.
Mounting into the Cabinet
Precautions
Before mounting RG-S12000 into the cabinet, first verify that the front and back brackets of the cabinet are at the right
locations. If the bracket is too far forward, the front panel of the equipment may be too close to the front door, so that the
front door cannot be closed when network cables and pigtail fibers are connected. Usually, you should reserve at least
10mm between the front panel of the equipment and that of the cabinet after installation. Before mounting into a cabinet,
you need to address the following conditions:
Fasten the cabinet.
Insert various modules in the frame properly.
Remove any obstacle in the frame and the surrounding environment.
Prepare the equipment and move it to the place near the cabinet where you can handle it easily.
Simple Installation Steps
1)
Levelly lift the RG-S12000 by two people on both sides, and slowly move it to the front of the cabinet.
