Chapter 2 Preparation Before Installation
Safety Suggestions
To avoid body injury and equipment damage, please carefully read the safety suggestions before you install
RG-S12000.
The following safety suggestions do not cover all possible dangers.
Safety Precautions for Installing the System
Keep the chassis clean, free from any dust.
Do not place the equipment in a walking area.
Do not wear loose clothes or any other things that may be caught by the chassis during installation and
maintenance.
Safety Precautions for Removal
RG-S12000 is large and heavy. When you handle them, please pay attention to the following requirements:
Avoid moving the equipment frequently.
Turn off all power supplies and unplug all power cables before you remove the equipment.
At least two people are needed to move the equipment. Do not attempt to move the equipment by one people only.
Keep balance when moving the equipment, and avoid injuring your leg and feet or spraining your waist.
Do not move the equipment by grasping the panel, power supply handle, ventilation holes of the chassis, as
they are not designed to bear the weight of the entire equipment. This may cause damage or even injure
you.
Remove all management modules, service modules and power modules before you move the device, to
reduce the chassis weight.
The device must be installed and used in the restricted access location.
Electrical Safety
Please observe local regulations and specifications when performing electrical operations. Relevant operators must
be qualified.
Please carefully check for any potential danger in the working area, for example, ungrounded power supply,
unreliable grounding of the power supply and damp/wet ground or floor.
Find out the location of the emergency power supply switch in the room before installation. First cut off the power
supply in case of an accident.
Be sure to make a careful check before you shut down the power supply.
Do not place the equipment in a damp/wet location. Do not let any liquid enter the chassis
