RST FRC-F Series, Manual

Page: 75 / 140

9.581.140-6
Page:
75
9.7.3 Selection of works-setting
In this menu you can call up the works-setting of the device for the
different operating modes.I
Vector control with asynchronous-machine and sine encoder
Vector control with asynchronous-machine and square wave encoder
Vector control with synchronous-machine (Geber EnDat)
Open-Loop mit asynchronous-machine
After selecting the appropriate operating mode with the E-key, the following message appears:
With the E-key factory settings are loaded. With ther C-key the procedure
can be cancelled.
Attention, the original settings are overwritten !
9.7.4 Configuration of inputs and outputs
In this menu, you can configure the inputs and outputs of the unit.
Extended
Works setting
----------------------
Extended
Inputs/outputs
----------------------
Works setting
Vektor Async.Sinus.
----------------------
○
Works setting
Vektor Async.Inkr.
----------------------
○
Works setting
Vektor Synchron
----------------------
○
Works setting
Open-Loop4
----------------------
○
Works setting
..sure ? <E>
----------------------
○