RST FRC-F Series, Manual

Page: 68 / 140

9.581.140-6
Page:
68
9.5.3 Selecting the unit mode (U/min or m/sec)
The setting of the speeds and the distances/times can be done either in reference to the motor speed
(rpm) or in reference to the cabin speed (m/sec).
As a standard, the unit mode is set to rpm.
To select unit mode metres/second, press the "E" key.
In the
Settings - General Settings
menu (see Section 8.3 ), three further
parameters are displayed now:
Here, you must enter the
transmission * 100 .
Example : Transmission = 53:2 --> entered value 26,5 * 100 = 2650
Here, you must enter the pulley diameter in mm.
Here, you must enter the suspension of the cabin.
Example : 1:1 --> entered value 1,
2:1 --> entered value 2
9.5.4 Unit operating modes
The following operating modes can be used:
Field-oriented mode with asynchronous machine
F/U control with asynchronous machine (see
Section 9.11.1 )
Field-oriented mode with synchronous machine, gearless (see
Section 9.10 ).
System
Units
----------------------
○
Units
rpm
----------------------
○
Units
m per sec
----------------------
○
Units
ok ..
----------------------
○
Setting
General Settings
----------------------
○
General Settings
trnsmiss 2650
----------------------
○
General Settings
Pull.dia 560
----------------------
○
General Settings
Susp dev 1
----------------------
○
System
Operating Mode
----------------------
○
Operating Mode
Vektor Asynchron
----------------------
○
Operating Mode
Open Loop4
----------------------
○
Operating Mode
vektor Synchron
----------------------
○