Roland VersaStudio BT-12, Operating Instructions Manual

Page: 120 / 234

5. Machine Setup Menus
118
7.
When "Set Maint. Kit Press Start key" is displayed, attach the cleaning tool to the
tray stand.
Push the cleaning tool to the back until it clicks.
DSA104
8.
Press the [Start] key.
Cleaning of the print head nozzles will start automatically. It takes 10 to 15 minutes.
Wait while "Maintenance in process..." is displayed.
9.
When "Remove Maint Kit Press Start key" is displayed, detach the cleaning tool,
and then press the [Start] key.
Wait while "Maintenance in process..." is displayed.
After that, the machine returns to its normal state.
10.
Press the [Escape] key until the top screen appears.
Clean Internals
The internal compartments clean automatically. Clean the interior if you do not use the
machine for a long time.
When cleaning the interior, use the optional dedicated cleaning cartridge.
• When cleaning the interior, a large amount of waste fluid is generated. Moreover, when
cleaning fails, a new ink cartridge or ink collector unit may be required due to additional
ink consumption or waste fluid generation. Clean the interior only if you do not use the
machine for three months or longer.
• Once cleaning of the interior has started, it cannot be canceled. Cleaning must be
completed before the machine can be used again. Once cleaning is completed, replace
the ink cartridge, turn the machine on, and provide the initial supply of ink. Once the
message "Ready" appears after the initial supply of ink is provided, you can use the
machine.