Roland VersaCamm SP-540V, Service Notes

Page: 162 / 182

6-10 MOTOR ERROR
NO CHECKING POINT ACTION REFERENCE OUTLINE
1 Media Jam
Remove cause of
Media Jam.
When the edges of the media curls or the media
absorbs the Ink and becomes to be irregular
surface of the media, the Head Carriage catches
on the media during printing and results in the
Motor Error.
2
Broken / life of the
Motor
Motor
Replacement
[3-5 Carriage
Motor
Replacement]
When the Motor is broken or reaches its life, the
Motor cannot obey the order from the CPU and it
results in the Motor Error.
3
Power Supply
voltage for Motor is
not supplied
Replace Switching
Power Supply
[3-13 SW Power
Supply
Replacement]
When the Power Supply voltage for the Motor is
not supplied, the Motor cannot move and it results
in the Motor Error.
4 Broken Motor Driver
Mainboard
Replacement
When the Servo Board is broken, the Power
Supply voltage for the Motor is not supplied and
the Motor cannot move. It results in the Motor
Error.
5
There is a dirt in
teeth of Drive Gear.
Clean Drive Gear.
When there is a dirt in the teeth of the Drive Gear
and it cannot rotate, the Motor Error occurs.
6
Weight of Media
exceeds usable
Media.
Use usable Media.
When the weight of Media is too heavy, the Motor
Error occurs due to the too much load for feeding
Media.
MOTOR ERROR
Bit
No.
0001
0004
0008
0005
0009
0010
0040
0080
0050
0090
0001 and 0008 occurred at the same
time.
0001 and 0004 occurred at the same
time.
Scan Motor Overcurrent Error 2
(A little load is put on the motor
movement for a long time.)
0010 and 0040 occurred at the same
time.
< ERROR DESCRIPTION
SCAN MOTOR ERROR
CODE : 0000 0000
CURRENT ERROR
< ERROR LIST >
MEANING CAUSE
Feed Motor Deviation Error
< User side >
1. Media Jam
2. Pull or Move the Carriage by hands.
3. Carriage runs into a thing/hands.
4. Media is stuck because the media end is not separated from the
paper tube.
5. Heavy media is used.
< Mechanical Side >
1. There is a bad contact/cut-line in the cable.
2. Screw fixing the tool carriage to wire is shifted.
3. Motor is broken./Life
4. Head/Servo Board is broken.
Feed Motor Overcurrent Error 1
(Big load is put on the motor movement
instantaneously.)
Feed Motor Overcurrent Error 2
(A little load is put on the motor
movement for a long time.)
Scan Motor Deviation Error
Scan Motor Overcurrent Error 1
(Big load is put on the motor movement
instantaneously.)
0010 and 0080 occurred at the same
time.
6-8
Record for LAST ERROR
Display the axis which the Error happens.
Revised 4
Revised 4