4-41
4
Input the values by pressing [ ], [ ], [ ] and [ ]
keys to minimize the gap between the print and the cut
at the 3 positions. An input is performed per 0.01mm
unit. (cutting position moves by this operation) Press
[ENTER] to save the adjustment value
4
Check the gap between the marks and cutting line.
5
6
For the check, press the [TEST CUT] key again and
perform the printing of a test pattern. Check the mark
printed / cut and gap of each mark and a cut line.
Adjustment has been completed if the quantity of the
gap in three points (the right, the left and middle) is the
minimum. If you can still see the large gap, repeat the
procedures 3-5.
F: 0.40 +0.01mm
S:-0.50 -0.20mm
F: 0.40 ----
S:-0.50 ----
F: 0.41 ----
S:-0.70 ----
+
-
+
-
F:
S:
[ENTER]
The dotted line shows cutting line.
To escape from the input screen of an
adjustment value, press the [MENU] button.
Please be careful that the adjustment value
changes if the [ ], [ ], [ ] or [ ] key is
pressed at this time.
The gap of the print&cut might be different.
depends on the position.
The dotted line shows cutting line.
Summary of Contents for VersaCamm SP-540V
