4-54
4
4-14 CAP HEIGHT ADJUSTMENT (Referential Time : 5min.)
[About CAP HEIGHT ADJUSTMENT]
CAP HEIGHT ADJUSTMENT is to adjust the height of the cap.
It must be done when you remove or replace the cap unit and replace and adjust the carriage unit. If this
adjustment has not been done there is a possibility that a CAP OPEN SUCTION is not performed correctly.
This adjustment can be performed in firmware version 2.10 and above.
*CAP OPEN SUCTION is an operation to suck ink without the heads capped. This can remove the ink
accumulated on the Cap surfaces due to the flushing done above the Caps.
1
2
Turn on the SUB POWER SW while pressing [
], [
]
and [
] keys to enter the SERVICE MODE.
Select the [CAP ADJUST] menu in the SERVICE
MENU and select [ADJUST POS.].
When the carriage is not in the capping position,
press [
] key to move the cap lower and then move the
carriage to the capping position.
-Note that the caps do not contact the head.
-When you press the [
] key, the cap moves to
the position in the setting value -2.00 mm.
-It is only possible to move the cap stepwise
to the upward direction in the [ADJUST POS.]
menu. When you move the cap in the
downward direction, press [
] key to move
the cap lower end once and then move
upward direction in 0.25 mm unit.
[ ], [ ], [ ] + POWER ON
[ MENU ] key
SERVICE MENU
Menu
SERVICE MENU
CAP ADJUST
CAP ADJUST
ADJUST POS.
Carriage
Cap
Summary of Contents for VersaCamm SP-540V
