Roland V-Card VC-1, Owner'S Manual

Page: 41 / 156

41
Transferring Patches To and From the D-50/550
Using the D-550
1.
Use a MIDI cable to connect the VariOS’s MIDI OUT connector to the D-550’s MIDI IN connector.
2.
Set the D-550 and V-Synth to the same MIDI channel (the basic channel; p. 80).
3.
Turn the Memory Protect of the D-550 to OFF .
3-1.
Press the D-550’s [TUNE] button.
3-2.
Select “ Protect ” with the [ ] or [ ] buttons, and turn it OFF with the [VALUE] .
4.
Enable reception of bulk load data on the D-550.
4-1.
Press the D-550’s
[DATA TRANS]
button.
4-2.
Select “
(B.Load)
” with the D-550’s
[ ]
or
[ ]
buttons, then press the
[ENTER]
button
while holding the
[DATA TRANS]
button.
4-3.
Press the
[ENTER]
button again.
fig.04-05a
5.
Turn the Exclusive Sw of the V-Synth to On .
5-1.
Press
[MODE]
.
5-2.
Touch
<SYSTEM>
.
5-3.
Select “
Exclusive Sw
,” then turn the V-Synth’s
VALUE
dial
to specify
On
.
6.
Press
[MODE]
on the V-Synth. The
MODE MENU
window appears.
7.
Touch <DATA TRANSFER> . The DATA TRANSFER screen
appears.
fig.04-06(LCD_DataTrans_BulkDump)
8.
Touch
<B.Dump>
in the left of the screen. The
MIDI Bulk Dump
screen appears.
9.
Modify the value by either turning the
VALUE dial
or pressing
[INC/+] or [DEC/-] .
Source Bank
Selects the Patch Bank in the VC-1 with the patch data to transfer
to the D-50.
Value: I1 – I8, P1 – P6
10.
Touch <OK> . The bulk dump starts. If you want to cancel without
executing, touch
<Cancel>
.
4-2
4-3 3-2 4-1
4-2 3-1 3-2
4-2
vc1_e.book 41 ページ ２００４年４月２日 金曜日 午後３時２１分