Roland TAIKO-1, Reference Manual

Page: 49 / 57

Appendix
49
LONG REVERB
This is a reverb with richer reverberations.
Parameter Value Explanation
Depth 0–127 Depth of the effect
Time 0–127 Time length of reverberation
Pre LPF
16–15000 [Hz] ,
BYPASS
Center frequency at which the high
frequencies of the input sound are filtered
(set this to BYPASS if you do not want to cut
the frequencies)
Pre HPF
BYPASS,
16–15000
[Hz]
Center frequency at which the low frequencies
of the input sound are filtered
(set this to BYPASS if you do not want to cut
the frequencies)
Peaking Freq
200–8000 [Hz]
Center frequency of the filter that boosts/cuts
a specific frequency region of the input sound
Peaking Gain -15–+15 [dB]
Amount of boost/cut produced by the filter
at the specified frequency region of the input
sound
Peaking Q 0.5–8.0
Bandwidth of the filter that boosts or cuts the
specified frequency region of the input sound
HF Damp
16–15000 [Hz] ,
BYPASS
Center frequency at which the high-frequency
content of the reverb sound is cut (BYPASS:
no cut)
LF Damp
BYPASS,
16–15000
[Hz]
Frequency at which the low-frequency content
of the resonant sound is cut (BYPASS: no cut)
Character 1–6 Reverb type
EQ Low Freq 200–400 [Hz] Center frequency of the low range
EQ Low Gain -15–+15 [dB] Amount of low range boost/cut
EQ High Freq 2000–8000 [Hz] Center frequency of the high range
EQ High Gain -15–+15 [dB] Amount of high range boost/cut
Level 0–127 Output level
SUPER FILTER
This is a filter with an extremely sharp slope (attenuation
characteristics). The cutoff frequency can be varied cyclically.
Parameter Value Explanation
Filter Type
Filter type
Frequency range that passes through each filter
LPF Frequencies at or below the cutoff
BPF Frequencies in the region of the cutoff
HPF Frequencies at or above the cutoff
NOTCH Frequencies other than the region of the cutoff
Filter Slope
Filter slope (attenuation characteristics; amount of attenuation per
octave)
-12 [dB] Gentle
-24 [dB] Steep
-36 [dB] Extremely steep
Filter Cutoff 0–127
Cutoff frequency of the filter
Increasing this value raises the cutoff
frequency.
Filter Resonance
0–127
Filter resonance level
Increasing this value emphasizes the region
near the cutoff frequency.
Filter Gain 0–+12 [dB] Amount of boost for the filter output
Modulation Sw OFF, ON On/off switch for cyclic change
Modulation Wave
These waves control how the cutoff frequency changes.
TRI Triangle wave
SQR Square wave
SIN Sine wave
SAW1 Sawtooth wave (upward)
SAW2 Sawtooth wave (downward)
SAW1 SAW2
Tempo Sync Sw OFF, ON
Sets whether the modulation rate is specified
as a note value (ON) or not (OFF).
Rate
0.05–10.00 [Hz] ,
note
Rate of modulation
Depth 0–127 Depth of modulation
Attack
0–127
Speed at which the cutoff frequency changes
This is effective if the Modulation Wave is SQR,
SAW1, or SAW2.
Level 0–127 Output level