Roland TAIKO-1, Reference Manual

Page: 39 / 57

Making Overall Settings for the TAIKO-1 (Others)
39
Configuring the Master Compressor
(Master Comp)
This is a two-band compressor that is provided for each kit.
The sound to which the master compressor is applied is output from
the OUTPUT jack and the PHONES jack.
5
Use this effect to raise the overall loudness by compressing brief peaks in the
sound. The compressor lets the sound project better, without being buried in the
mix by the other instruments.
5
The compressor-limiter lets you increase the recording level while limiting the
excessive level input to the recording device.
5
The limiter makes the sound less likely to distort if you’re using a small monitor
amp, by limiting peaks in the sound.
1 .
On the OTHERS screen, select “Master Comp” and
press “SELECT”
(F2 button)
.
The MASTER COMP screen appears.
2 .
Use the [
H
] [
I
] buttons to select the item, and then
use the [+] [-] buttons to change the setting .
Parameter
[
H
] [
I
] buttons
Value
[+] [-] buttons
Explanation
Comp Sw OFF, ON Turns the master comp on/off.
Split Freq
SINGLE,
10–16000
[Hz]
When the compressor bandwidth is
“SINGLE,” this effect operates as a single-
band compressor only on the high range.
Gain *1 -24–+24 [dB] Sets the compressor output level.
Threshold *1 -48–0 [dB]
Sets the volume level at which compression
starts.
Ratio *1 1:1–100:1 Sets the compression ratio.
Knee *1 HARD, SOFT1–3
Sets the attack of the sound at the moment
compression is applied.
Attack *1 0.1–100 [ms]
Sets how long it takes before compression
is applied.
Release *1 10–1000 [ms]
Sets how long it takes before the
compression returns to normal.
* 1
If Split Freq is set to something other than “SINGLE,” the low range and
high range can be set independently.
2 .
Press the F1 button several times to return to the top
screen .
Setting the Screen and AUTO OFF Function
(LCD/Auto Off)
You can adjust the brightness of the screen, and make other system
settings.
1 .
On the OTHERS screen, select “LCD/Auto Off” and
press “SELECT”
(F2 button)
.
The LCD/AUTO OFF screen appears.
2 .
Use the [
H
] [
I
] buttons to select the item, and then
use the [+] [-] buttons to change the setting .
Parameter
[
H
] [
I
] buttons
Value
[+] [-] buttons
Explanation
LCD Contrast 1–16 Display contrast
LCD Backlight
1–16 Display brightness
Auto Off
OFF The power does not turn off automatically.
4 HOURS
When four hours have elapsed without any
pad being struck or any operation being
performed, the unit turns off automatically.
10 MINUTES
When 10 minutes have elapsed without any
pad being struck or any operation being
performed, the unit turns off automatically.
3 .
Press the F1 button several times to return to the top
screen .
Viewing Information for This Instrument
(Version Info)
This shows information related to the TAIKO-1 itself, such as the
program version.
1 .
On the OTHERS screen, select “Version Info” and press
“SELECT”
(F2 button)
.
The VERSION INFO screen appears.
2 .
Press the F1 button several times to return to the top
screen .