Rohde & Schwarz VSE-K149, User Manual

Page: 37 / 143

Configuration
R&S
®
VSE-K149
37 User Manual 1179.3315.02 ─ 01
Capture Time .................................................................................................................37
Channel .........................................................................................................................37
Default Values ............................................................................................................... 38
Sample Rate ................................................................................................................. 38
Maximum Bandwidth .....................................................................................................38
Analysis Bandwidth ....................................................................................................... 38
Capture Time
Specifies the duration (and therefore the amount of data) to be captured in the capture
buffer. If the capture time is too short, demodulation will fail. In particular, if the result
length does not fit in the capture buffer, demodulation will fail.
When connecting to an R&S RTP oscilloscope, different modes are possible. See
R&S
VSE base unit user manual for further details. The maximum capture time
depends on the available software and hardware options of the connected R&S RTP
oscilloscope.
Remote command:
[SENSe:]SWEep:TIME
on page 126
Channel
Selects the HRP UWB Channel according to the IEEE 802.15.4z-2020 standard, a
center frequency and a measurement bandwidth is predefined. By selecting the "Set
CF" button, the center frequency of the R&S
VSE is set according to the definition in
the selected channel.
Remote command:
[SENSe:]CAPTure:PRESet
on page 126
[SENSe:]CAPTure:FSET
on page 127
Data Acquisition