Command Reference
R&S
®
CMW-B400B/-B405A
52
User Manual 1176.8116.02 ─ 04
6 Command Reference
The following sections provide detailed reference information on the remote con-
trol commands of the audio applications.
Conventions and General Information
.................................................................... 52
.............................................................................................. 58
6.1 Conventions and General Information
The following sections describe the most important conventions and general informa-
tion concerning the command reference.
6.1.1 MEAS<i> and GEN<i>
MEAS<i> is used as abbreviation of "MEASurement<instance>", GEN<i> as abbrevia-
tion of "GENerator<instance>". For better readability only the abbreviated form (which
is also accepted by the instrument) is given in the command reference.
The <instance> is relevant for instruments supporting several instances of the same
firmware application. It can be omitted if the instrument supports only one instance, or
to address the first instance.
See also: "Firmware Applications" in the R&S
CMW user manual, chapter "Remote
Control"
6.1.2 FETCh and READ Commands
All commands are used to retrieve measurement results:
●
FETCh...
returns the results of the current measurement cycle (single-shot mea-
surement) after they are valid.
FETCh...
must be used after the measurement
has been started (
INITiate...
, measurement states RUN or RDY).
●
READ...
starts a new single-shot measurement and returns the results.
See also: "Retrieving Measurement Results" in the R&S
CMW user manual, chapter
"Remote Control"
6.1.3 Current and Statistical Results
The R&S
CMW repeats measurements according to the selected statistic count and
repetition mode. Consecutive measurement values are stored and used to calculate
statistical results, e.g. average, minimum, maximum and standard deviation.
Conventions and General Information
深圳德标仪器
135-1095-0799
