Rodgers W-5000, User Manual

Page: 17 / 165

Introduction & Installation
17
INSTALLING THE PEDALBOARD
Once the instrument is secured to the stand, it will be necessary to install the Pedalboard.
First, however, free the two pedal cables that are temporarily secured by a fastener to the underside of the
stand. (Do not remove this fastener from the base of the instrument. Before moving the W-5000, be sure that
these cables are carefully bundled (without any slack) and secured to the base using the fastener.)
[NOTE:
Refer to the following page for information on pedalboard installation for the "A" version of the W-
5000.]
SPKR
LINE -
+
- +
1
NOTE: If your W-5000 is sitting on a very thick carpet, it may be difficult to slide the Pedalboard into place.
If that is the case, very carefully lift one side of the instrument and rotate the adjustable feet to provide more
clearance. Then lift the other side and do the same.
Take great care when making this adjustment; this
500 pound instrument could cause severe injury if it were to pinch fingers or toes!
Ê Connect the pedal cables to the
receptacles on the right side of the
Pedalboard assembly; one is a 5-
pin cable for the Pedalboard) and
the other is an 8-pin cable (for the
Expression pedal).
Ë Push the pedalboard (from the
center of the heelpad) so it slides
all the way into the stand.
5-pin 8-
i