Rodgers W-5000, User Manual

Page: 15 / 165

Introduction & Installation
15
1 MIXED LINE
These XLR connectors allow you to connect your W-5000 to a mixing console BALANCED
INPUT (using long cables if necessary). The signal from these connectors is a Line level mix
of the individual outputs (SYNTH, DRAWBAR and CLASSIC).
2 RODGERS This is the standard Rodgers connector for the main individual outputs MAIN
OUTPUT(SYNTH, DRAWBAR and CLASSIC) and the MIXED LINE or SPKR OUTPUT.
It also sends a 'power on' signal to any connected amplifier(s).
3 AUX INPUT These XLR inputs accept connection of microphones, external keyboards etc. Sensitivity and
other controls are accessible through the [AUDIO] button in the FUNCTIONS section.
4 RODGERS This is the standard Rodgers connector for MIXED LINE Output. It also sends a
ANTIPHONAL OUTPUT 'power-on' signal to any connected amplifier(s).
5 AUX INPUT These 1/4" inputs accept connection of microphones, sound modules, external keyboards etc.
Sensitivity and other controls are accessible through the [AUDIO] button in the
FUNCTIONS section.
6 SYNTH
OUTPUT
These 1/4" jacks provide an individual, line-level output for sounds from the Synth tone
generator. For the best results, use both jacks.
7 DRAWBAR
OUTPUT
These 1/4" jacks provide an individual, line-level output for sounds from the Tone-Wheel
generator. For the best results, especially when the Rotary simulator is active, use both jacks.
8 CLASSIC
OUTPUT
These 1/4" jacks provide an individual, line-level output for sounds from the Classic Organ
tone generator. For the best results, use both jacks.
9 MIXED SPKR These 1/4" jacks provide a line-level output for the same signals going to the OUTPUT
internal amplifier and speakers (the Speaker mix).
10 MIXED LINE These 1/4" jacks provide an option for connection to a mixing console (an OUTPUT optional
Line mix output).
11 MIDI 1 These MIDI ports allow you to connect your W-5000 to external MIDI devices (such as
sound modules, sequencers etc.). Control of these ports is accessed through the [MIDI]
buttons found in each section (UPPER/LOWER/BASS) and the [MIDI] button in the
FUNCTIONS section.
12 MIDI 2
Same as MIDI Port 1 without the THRU connector.
13 SW1 This 1/4" jack accepts connection of an external, switched (on/off) controller. The function
of this controller is user defined.
14 PEDAL This 1/4" jack accepts connection of an external controller (such as an Expression pedal).
The function of such a controller is user defined.
15 ACC POWER This is a general purpose 12v DC power outlet. It can be used to power an external piece of
equipment (like a Rodgers PR-300, for example).
16 ROTARY TONE
CABINET
This multi-pin connector is used to connect a rotary tone cabinet to your W-5000.
17 SPEAKER/
EXPRESSION
PEDAL
This multi-pin connector is used to connect the on-board speakers and Expression pedal
(both integrated into the stand) to the keyboard.
18 MAIN POWER Connect the included AC power cord to this inlet.