Rodgers W-5000, User Manual

Page: 117 / 165

Appendix
117
EFFECTS SECTION
[MANUAL DRUMS] Parameters
These parameters affect Manual Drums functions. Press the [MANUAL DRUMS] button in the EFFECTS
section to access these parameters:
Manual Drums
Split: E2-G8
This parameter allows you to set the manual drums split point. Use the [+] and [-] (or [++]/[--]) buttons to set
the split point.
Manual Drums
Standard Set 1, Standard Set 2, Room Set, Power Set, Electric Set, TR808&909
Set, Dance Set, Jazz Set, Brush Set, Orchestra Set, Ethnic Set, Kick/Snare Set,
SFX Set, Rhythm FX Set
This parameter allows you to select the desired Drum Set. Press [NEXT] to select this parameter. Use
the[+]/[-] buttons to select the Drum Set. (These Drum Sets are available when the 'Synth Drums' Tone map
is selected, see page 146.)
Map: Synth Drums, PR-300 Drums
This parameter allows you to select the desired Tone map for Manual Drums sounds. Press [NEXT] to select
this parameter. Use the[+]/[-] buttons. (Synth Drum Sets are listed on page 146 and PR-300 Drum Sets are
listed on page 147.)
Volume: 0-127
This parameter allows you to select the overall volume for Manual Drums sounds. Press [NEXT] to select
this parameter. Use the[+]/[-] or [++]/[--] buttons.
[UPPER DB VIB] + [LOWER DB VIB] Parameters
These parameters affect Drawbar vibrato and are accessible when you press either the [UPPER DB VIB] or
[LOWER DB VIB] button in the EFFECTS section:
Drawbar Vibrato
Rate: 0-127
This parameter allows you to select the rate (speed) of the vibrato effect. Use the [+] and [-] buttons to set the
rate.
Depth: 0-50
This parameter allows you to set the vibrato depth (intensity). Press the [NEXT] button to select this
parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the vibrato depth.
Efx Level: 0-127
This parameter allows you to adjust the level of the vibrato effect. Press the [NEXT] button to select this
parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the level.
Dry Level: 0-127
This parameter allows you to set the level of the dry (unprocessed) signal. Press the [NEXT] button to select
this parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the level.