37
Assembly - Damper Shaft, Eyelet, and Reservoir
Install the lower rebound adjuster ring seal.
Orient the rebound adjuster ring with the adjuster ring detent (A) stop
aligned with the (B) detent ball, the (C) detent pin with the adjuster ring
(D) stop, and the rebound adjuster ring (E) set screws aligned with the
set screw (F) slide stops.
When installed, the rebound adjuster should be in the full-open
position.
Tighten each rebound adjuster set screw and stop when the top of
each set screw is flush with the rebound adjuster. The adjuster should
be able to rotate freely and should not be able to be removed.
When rotated clockwise, the full range of rebound clicks should be
available.
Rotate the adjuster and test the range before tightening the set screws.
The number of rebound clicks should be equal to the number of clicks
before the shock was disassembled.
12
13
B
F
E
E
C
D
F
A
14
1.5 mm
