8
Disassembly - Damper Shaft and Eyelet
Ultimate RCT, RL, RT, Select R:
Clamp the damper
shaft into a vise with RockShox Vise Blocks (3-hole) (10 mm slot),
threads down, just below the eyelet.
Ultimate RCT pictured
: Procedure is the same for all models.
Secure the wrench on the (A) eyelet mount flats (standard, trunnion, or
bearing). Unthread and remove the eyelet assembly from the damper
shaft assmebly.
Ultimate RCT pictured
: Procedure is the same for all models.
Eyelet
Wrench
Standard
13 mm
Bearing
29 mm
Trunnion
54 mm
Remove the damper shaft assembly from the vise and vise blocks and
set it aside.
Ultimate RCT pictured
: Procedure is the same for all models.
If the original eyelet assembly will be replaced:
Discard the original
eyelet assembly.
If the original eyelet assembly will not be replaced and damper shaft
will be replaced:
Clean the eyelet shaft threads with a shop towel.
Remove all (A) threadlocker. Tap the eyelet on a flat surface to remove
any loose bits of threadlocker as needed. Do not spray alcohol or
cleaner into the eyelet.
Ultimate RCT pictured
: Procedure is the same for all models.
3
RockShox Vise Blocks (3-hole) - 10 mm slot
RockShox Vise Blocks (3-hole) - 10 mm slot
4
Adjustable open end wrench
A
5
6
Threadlocker
A
