35
Assembly - Damper Shaft, Eyelet, and Reservoir
Install the Bottomless Token(s), if previously installed, into the eyelet.
Install the (A) bottom out bumper and washer, and the (B) travel limiter
and washer (if previously installed), in that order, onto the damper shaft.
Insert the damper shaft assembly, needle first, into the eyelet. Seat the
needle and thread the damper shaft assembly into the eyelet by hand
until it stops.
Clamp the damper shaft into a vise with RockShox Vise Blocks (3-hole)
(10 mm slot), just below the eyelet.
Secure a crowfoot wrench on the (A) eyelet mount flats (standard,
trunnion, or bearing). Tighten the eyelet to the specified torque.
Eyelet
Crowfoot
Standard
13 mm
Bearing
29 mm
Trunnion
54 mm
4
5
B
A
A
B
6
7
See table
7.9 N•m (70 in-lb)
A
