RMG TME400-VC, Operating Manual

Page: 61 / 112

4 Operation
MANUAL TME400-VCF · EN04 · 2019 March 26th
55
VI. With the and arrows, you can now increase or decrease the value at
this position. For the values, after the "0", you also have "-1" available in order
to enter negative values, if necessary.
VII. With the and arrows, you can move to a different position of the
value and change it
– as described in the point above.
VIII. An additional position is added when you move with the and before
the displayed number.
For example, only the units digit is displayed. If you move in front of it, you will
also have the tens position available as an entry.
IX. By pressing and holding the "right" button , the position of the decimal
point is changed. After pressing and holding, the decimal point is inserted after
the blinking digit.
X. By pressing and holding the "left" button , the entry can be canceled. If a
change and/or entry is necessary, the entry must be restarted.
XI. When you have finished making an entry, you confirm it by briefly pressing
.
XII. A plausibility check takes place and the result is displayed immediately.
XIII. If this check shows an implausible entry, "rAnGE" will be shown briefly in the
display and the display jumps back to the original value.
XIV. If this check shows an plausible entry, "Good" will be shown briefly in the dis-
play and the value is adopted as a new value.
XV. Now you can
– if necessary – change other parameters.
XVI. After about 1 minute without additional entries, the display returns to the dis-
play of the main totalizer.
XVII. By pressing the calibration, you close the further entry of custody-transfer pa-
rameters.
XVIII. After another minute without an entry, the change possibility is closed auto-
matically.
Note
Some of the coordinates permit other settings as purely numerical values.
However, these other entries are assigned numbers so that the adjustment
can be carried out as described.