RME Audio Fireface 802, User Manual

Page: 97 / 112

User's Guide Fireface 802 © RME 97
DA, Line Out 1-8, rear
•
Resolution: 24 bit
•
Dynamic range (DR): 115 dB RMS unweighted, 118 dBA
•
Frequency response @ 44.1 kHz, -0.5 dB: 5 Hz – 20.8 kHz
•
Frequency response @ 96 kHz, -0.5 dB: 5 Hz – 45 kHz
•
Frequency response @ 192 kHz, -1 dB: 5 Hz - 89 kHz
•
THD: < -110 dB, < 0.00032 %
•
THD+N: < -104 dB, < 0.00063 %
•
Channel separation: > 110 dB
•
Maximum output level: +19 dBu
•
Output: 6.3 mm TRS jack, servo-balanced
•
Output impedance: 75 Ohm
•
Output level switchable Hi Gain, +4 dBu, -10 dBV
•
Output level at 0 dBFS @ Hi Gain: +19 dBu
•
Output level at 0 dBFS @ +4 dBu: +13 dBu
•
Output level at 0 dBFS @ -10 dBV: +2 dBV
DA - Stereo Monitor Output Phones (9-12)
As DA, but:
•
Output: 6.3 mm TRS stereo jack, unbalanced
•
Maximum output level at 0 dBFS, High: +16.8 dBu
•
Output impedance: 30 Ohm
34.2 MIDI
•
1 x MIDI I/O via 5-pin DIN jacks
•
Galvanically isolated by optocoupled input
•
Hi-speed mode: Jitter and response time typically below 1 ms
•
Separate 128 byte FIFOs for input and output
34.3 Digital
•
Clocks: Internal, ADAT In, AES In, word clock in
•
Low Jitter Design: < 1 ns in PLL mode, all inputs
•
Internal clock: 800 ps Jitter, Random Spread Spectrum
•
Jitter suppression of external clocks: > 30 dB (2.4 kHz)
•
Effective clock jitter influence on AD and DA conversion: near zero
•
PLL ensures zero dropout, even at more than 100 ns jitter
•
Digital Bitclock PLL for trouble-free varispeed ADAT operation
•
Supported sample rates: 28 kHz up to 200 kHz