RME Audio Fireface 802, User Manual

Page: 87 / 112

User's Guide Fireface 802 © RME 87
In stand-alone mode the unit always operates in
View Submix
mode. Only this way the routing
destination can be changed, and several mixdowns/submixes can be set up quickly and easily.
If the current TotalMix setup is transferred into the Fireface via 'Flash current mixer state', the
currently selected submix output is also pre-configured in the hardware for stand-alone MIDI
remote operation.
Mackie Control Protocol
The stand-alone operation supports the following Mackie Control surface elements*:
*Tested with Behringer BCF2000 Firmware v1.07 in Mackie Control emulation for Steinberg mode.
Element: Meaning in Fireface:
Channel faders 1 – 8
volume
V-Pots 1 – 8 pan
pressing V-Pot knobs pan = center
CHANNEL LEFT or REWIND
move one channel left
CHANNEL RIGHT or FAST FORWARD move one channel right
BANK LEFT or ARROW LEFT move eight channels left
BANK RIGHT or ARROW RIGHT move eight channels right
ARROW UP or Assignable1/PAGE+ move one row up
ARROW DOWN or Assignable2/PAGE- move one row down
STOP
Dim Main Out
EQ
Master Mute
MUTE Ch. 1 – 8 Mute
SELECT Ch. 1 – 8 Select
REC Ch. 1 – 8 select output bus (current submix)
F1 – F6
load Setup 1 - 6
Additionally the following functions are available in stand-alone mode via simple MIDI notes on
MIDI channel 1:
Dim
: 5D / 93 /
A 6
Setup 1
: 36 / 54 /
#F 3
Setup 2
: 37 / 55 /
G 3
Setup 3
: 38 / 56 /
#G 3
Setup 4
: 39 / 57 /
A 3
Setup 5
: 3A / 58 /
#A 3
Setup 6
: 3B / 59 /
B 3
Loading the Setups stored in the device enables a quick configuration change of the 802. With
this any possible operation state can be activated by the push of a button at any time.