Rioned CityJet, User Manual

Page: 43 / 98

OPERATION: STANDARD FUNCTIONS
43
6. Increase the speed by pressing button 2 ‘Increase speed’ (9-channel) or button 6 ‘Throttle up’
(11-channel).
7. Let the engine warm up. After three minutes of warming up, the machine is ready for use.
4.4.3 Unblocking a sewer
4.4.4 Spray nozzle warning
How do you prevent this?
A mark has been applied approximately five meters from the end of the hose. When you see this mark, do
the following:
1. Turn off the high pressure.
2. Then pull the hose completely out of the pipe.
4.4.5 Preparations for spraying
The machine has two spray nozzles for unblocking sewers: ‘Open nozzle’ and ‘Blind nozzle’.
1. Attach the spray nozzle to the end of the high pressure hose as follows:
• first fit the O-ring to the threads of the high pressure hose
3. Now switch on the Riomote control.
The Lightbar stops flashing and stays blue when the Riomote control is
connected to the receiver.
Check to see if a fault icon is displayed:
• If there is a fault icon: see section ‘
Navigation bullets
’.
• No fault icon: continue with the next step.
4. For safety reasons, remove the key from the e:
5. Press button 6 ‘Start motor’ (9-channel) or button 2 ‘Start’ (11-channel) on
the Riomote control.
The engine is now started.
When the engine is running, the engine LED is blue:
WARNING!
Ensure that the spray nozzle never exits the sewer while
spraying. A high pressure water jet can cause serious injuries!