Rioned CityJet, User Manual

Page: 46 / 98

OPERATION: STANDARD FUNCTIONS
46
Stopping spraying with the Riomote control
> Press button 3 ‘Stop spraying’ (9-channel) or button 3 ‘HP off’ (11-channel) on the Riomote control.
> The LED for high pressure on the e goes out.
> No more water comes out of the nozzle.
> The engine speed decreases.
4.4.8 Handling the high pressure hose
Handling the high pressure hose carefully:
>
Make sure there are no sharp objects near the hose.
> Make sure no vehicles drive over the hose.
> Clean the hose after each use.
> Use only the special repair couplings if the hose requires repair.
4.5 Cleaning a wall, terrace or floor
4.5.1 Warnings for spray gun
See also the safety instructions for the spray site in the Introduction.
4.5.2 Preparations for spraying
1. Attach the spray gun to the end of the high pressure hose as follows:
• First fit the O-ring to the threads of the high pressure hose.
> The text ‘High Pressure OFF’ is displayed for two seconds:
> No more water comes out of the nozzle.
> The engine speed decreases.
WARNING!
ALWAYS observe the following warnings when working with the spray gun:
Before use:
•
Set the pressure regulator to half of the maximum operating pressure (see
section ‘Symbols on pressure gauge, pressure regulator and valve controls’).
• Then start the machine.
After starting and while working:
•
The operating pressure can be increased to the desired pressure. Do this by
turning knob on the pressure regulator.
• NEVER exceed the specified maximum operating pressure! (See section
‘Symbols on pressure gauge, pressure regulator and valve controls’.)