RiMO SiNUS iON, User And Maintenance Manual

Page: 64 / 148

4 | Transport and installation
64 / 148 User and maintenance manual
a) Position the kart safely at an ergonomically suitable height (e.g. with KHB 250 lifting platform).
b) Apply assembly paste to the front axle steering knuckles.
NOTICE! The assembly paste is not included in the scope of delivery and can be purchased separately
from RiMO. Contact RiMO service department for advice. Product no.: 1892036 - HSP 1400 lubrica-
tion, disassembly and corrosion protection paste
c) Slide the rear wheels onto the wheel centre. Slide the front wheels onto the steering knuckles. Ensure that
the wheels do not become jammed or misaligned and prevent damage to the threads.
NOTICE! The narrow wheels are the front wheels. The wide wheels are the rear wheels. If the wheels
feature a direction mark arrow, observe it.
d) Rear axle: Mount the three hexagon nuts and tighten them with the prescribed torque (see Tightening tor-
ques [

129] ).
e) Front axle: Mount the hexagon nut and tighten it a little. Turn the wheel to check whether it rotates freely. If
the wheel rotates freely, tighten the hexagon nuts further and check again for free rotation. If the wheel does
not rotate freely, the hexagon nut has been tighten too far. In this case, increase the axial bearing play
(max. permissible axial bearing play: 0.5 mm). Loosen the hexagon nut and check against for free rotation.
f) Adjust the hexagon nut so that the wheel rotates freely.

Proceed accordingly to mount the second wheel.
Mounting steering wheel
Depending on the transport requirements, the steering wheel might have been removed from the kart prior to
shipping. After unloading the kart, mount the steering wheel.
Fig. 41:
Steering wheel installation
1 Screws of steering wheel cover 2 Steering wheel
3 Steering wheel cover 4 Steering wheel mount
5 Securing screws of steering wheel

The kart is placed the ground.

Depending on the steering wheel model, a signal cable might need to be fed through the steering column to
the steering wheel. The plug of the steering cable must protrude from the steering column prior to mounting
the steering wheel.