9 | Repairs
136 / 148
User and maintenance manual
b)
Mount the brace and secure the cell pack by tightening the screws. Make sure that the temperature sensors
are in the same positions as before and that they cannot be come squeezed or otherwise damaged.
c)
Mount the sense boards and cell connectors.
d)
Lift the cell pack into the side box. Ensure that none of the cables and components is damaged in the pro-
cess. Observe the pack polarity.
e)
Connect the load cable and the main power cable.
f)
Connect the sense boards to the BMS.
g)
Replace the side box lid and secure it with the screws. Ensure that none of the cables and components is
damaged in the process.
The new cell is now installed.
Starting the kart
The kart can now be started (see
Should the new cell not be automatically detected by the BMS, connect the charger and fully charge the kart
(100 %).
This charging process might take a bit longer than usual, as the new cell is balanced by the BMS with the exist-
ing cells.
9.1.2
Replacing transmission
When replacing the transmission, make sure that the clamping hub between the motor and the transmission is
tightened with a torque of 35 Nm. When inserting the motor shaft into the transmission, ensure that the clamping
hub, the clamping sleeve and the motor shaft are free from grease.
The slots of the clamping hub and the clamping sleeve must be aligned to the groove in the motor shaft.
If you need to replace the transmission, contact RiMO service department.
9.2
Repairs to be carried out by RiMO
All welding and alignment work on the frame and attached components must be carried out by RiMO.
Repairs on defective or faulty components are not admissible. These components must be replaced with new
ones.
