RiMO SiNUS iON, User And Maintenance Manual, Page: 60 / 148

4 | Transport and installation
60 / 148 User and maintenance manual
4 Transport and installation
Prior to delivery, the kart has been assembled, configured and tested at the factory. For transport, the kart might
have been disassembled.
In order to prevent serious or even fatal injury or damage to property during transport and installation, adhere to
the following instructions:
– All work in connection with the transport of the kart must be performed by qualified and authorised personnel.
– All lifting gear and lashing devices must conform to the applicable accident prevention regulations.
– The lifting gear and lashing devices must be suitable for the weight of the kart (see Technical data [

43] ).
– Ensure that the transport paths are sufficiently large for safe manoeuvring. Door and gate openings must be
at least 5 cm wider and higher than the transport unit including the transport vehicle.
– Have the transport path secured by a third person.
For safest and fastest installation, following the installation procedure described in this manual.
The chapters below describe the steps to be completed for the safe and proper transport and installation of the kart.
Safety instructions for transport and installation
– All work on the electrical system must be carried out by qualified electricians.
– Reading this manual is no substitute for proper training!
4.1 Required tools
The following tools are required for the installation of the kart:
– Spanners (of various sizes)
– Screwdrivers (of various sizes)
If special tools are required, these are specified in the relevant section of this manual.
4.2 Lashing points
The kart is shipped on a special transport pallet. The lashing points are clearly labelled.