8 | Checks and servicing during operation
124 / 148
User and maintenance manual
8.2.3.11
Maintenance of gas sensor
When the gas pedal is in its zero position, the gas sensor must not be actuated.
Fig. 73:
Gas sensor
1 Gas sensor
2 Gas pedal
3 Securing screws
Adjusting gas sensor
The kart is switched off.
a)
Position the kart safely at an ergonomically suitable height, for instance by placing it on an assembly trolley
or a lifting platform (e.g. KHB 250 EH, prod. no.1397002).
b)
Loosen the securing screws of the gas sensor and adjust it so that the sensor is not actuated when the gas
pedal is in its zero position, but the kart is accelerated at the maximum rate when the gas pedal is pushed to
the stop.
c)
Tighten the screws with a tightening torque of < 1 Nm. When tightening the screws, ensure that the gas
sensor is not turning.
d)
After tightening the screws, test the gas pedal and gas sensor functions again.
e)
If necessary, repeat the above adjusting procedure.
The gas sensor is now correctly set.
8.2.4
Checking and servicing electrical parts
a)
Regularly inspect the electrical components for damage.
b)
If you detect any damage to electrical parts, immediately remove the kart from the track and have it repaired
by a qualified workshop, using original spare parts.
See also
1
2
3
3