8 | Checks and servicing during operation
128 / 148
User and maintenance manual
The kart is standing still.
a)
Ensure that the
drive switch is pushed in (OFF position).
b)
Switch on the
main switch.
c)
Switch on the charger and connect the charging plug to the kart. Ensure that the plug is fully inserted into
the socket. For more information, refer to
or contact RiMO service department.
The charging process starts automatically.
When the batteries are fully charged (100 %), LED 1 and LED 3 are lit in green and message "END" is
displayed on the charger display. Also, the battery charge indicator in the kart indicates that 100%
charge is reached.
d)
Disconnect the charging plug from the kart.
CAUTION! Do not disconnect the charging plug while the kart is being charged. Do not disconnect
the charging plug by pulling the cable.
The batteries are fully charged.
NOTICE
Reducing or interrupting charging current
Towards the end of the charging process, the charging current might be gradually
reduced or interrupted for short periods of time. This behaviour is known as "toggling"
and helps balancing the cells, thus enhancing the capacity of the batteries.
Disconnecting charger from mains power
The charger is powered through a mains lead. Disconnect the charger from the mains power supply, if:
–
The charger is not regularly in use.
–
The charging electronics are to be reset, e.g. following a fault message.
See also
Exchanging/replacing battery cells [
