RIDGID 57276, Manual

Page: 5 / 194

999-995-118.0 9 _REV A
3
DP-13 Descaling Pump
3
RIDGID Contact Information
If you have any question concerning this RIDGID
®
prod-
uct:
– Contact your local RIDGID distributor.
– Visit RIDGID.eu to find your local RIDGID contact point.
– Contact Ridge Tool Technical Service De part ment at
RIDGID.eu@emerson.com or +32 11 598 600.
Description
The RIDGID
®
DP-13 Descaling Pump is designed for
descaling of closed-circuit systems like boilers, heat ex-
changers and closed heating systems.
The pump is equipped with motorized flow reversing to re-
move the scale deposit from both directions of the circuit.
The pump has an integral tank to add descaling solution
for easy removal of scales.
Figure 1 – RIDGID DP-13 Descaling Pump
Figure 2 – Pump Serial Number
Specifications
Flow Rate ......... 33 liter/min
Head ................. 10 m
Tank Capacity ...13 liter
Motor .................230V, 50Hz, 0.20 Hp
Speed ............... 2800 rpm
Descaling
Chemicals ........ Use Commercially Available Following
These Guidelines Below
Maximum
Temperature ..... 50 °C
Hose Length .... 2 m
Connections ..... ½" BSP Thread
Protection ......... IP54
Dimension
(L x W x H) ....... 520mm x 460mm x 280mm
Weight .............. 8 kg
Sound Pressure
(L
PA
)* ................. < 63.9 dB(A), K=3.16 dB(A)
Sound Power
(L
WA
)* ................ < 74.8 dB(A), K=3.16 dB(A)
* Sound measurements are measured in accordance with a standardized test per
Standard EN 62481-1.
- Sound and vibration emissions may vary due to your location and specific use
of these tools.
- Daily exposure levels for sound need to be evaluated for each application and
appropriate safety measures taken when needed. Evaluation of exposure lev-
els should consider the time a tool is switched off and not in use. This may
significantly reduce the exposure level over the total working period.
This descaling pump is made to descale pipes
and tubing with proper descaling chemicals. If properly
used, it will not damage a system that is in good condition
and properly designed, constructed and maintained. If the
system is in poor condition, or has not been properly de-
signed, constructed and maintained, the descaling process
may not be effective or could cause damage to the system.
Improper use of this descaling pump can damage the pump
and the system. This pump may not remove all scales.
Warning Label
Motor
Hoses
Serial Number
Plate
Handle Date Code (on top of
motor, indicates the
month and year of
the manufacture)
I-O-II Switch
Shoulder Strap
Hose Caps
Tank Cap
Hose Wrap
Max Level
Tank
Maximum
Chemical Allowable
Concentration
Descaling C2H4O2 (Acetic acid) < = 20%
Chemicals for HCI (Hydrochloric acid) < = 20%
Use With DP-13 C6H8O7 (Citric acid) 100%
CH2O2 (Formic acid) < = 25%
H3PO4 (Phosphorus acid) < = 20%
H3NO3S (Sulphamic acid) < = 15%
Descaling HF (Hydrofluoric acid)
Chemicals Not HNO3 (Nitric acid)
Allowed With H2SO4 (Sulphuric acid)
DP-13 3HCI + 1 HNO3 (Aqua Regia)
NOTICE