S-SERIES PRIVATE USE SERVICE MANUAL
MAINTENANCE
SEPTEMBER 2020
3- 11
32DSW02.F
9. Place gas spring (P/N 39368) in baseplate as shown in
Figure 3-19
.
10. Route cable (P/N 35233) onto grooved bearing (P/N VS-AH-06).
11. Tighten ¼-20 x 7/8” screw (P/N 39370) and lock nut (P/N 14-08-304) and secure pulley shield onto clevis.
12. Refer to
Figure 3-21
. Align threaded end of gas spring into bracket hole then fasten to baseplate with
nut.
NOTE:
Apply medium strength thread lock (Loctite 243) to threaded end of gas spring before installing nut.
FIGURE 3-21
13. Pull cable and insert wooden block (or similar) in baseplate, as shown in
Figure 3-8
,
Section E. Allow
slack in cable.
14. Install existing hex screw to anchor the cable end onto the baseplate as shown in
Figure 3-10
, Section E.
NOTE:
Ensure that the delrin cable guide retained from removal procedure is reinstalled.
15. Partially stow lift to remove wooden block (or similar) from baseplate as shown in
Figure 3-8
, Section E.
Tension to cable will be restored when wooden block is removed.
16. Replace center access cover and re-install center access cover screws.
17. Deploy and stow lift to ensure that gas spring and cable are working properly.
G. MAIN ROLLER ASSEMBLY REPLACEMENT
A. ROLLER REMOVAL
1. Deploy platform to ground and open pump release valve by turning valve counter-clockwise.
CAUTION
Do not open pump release valve more than ¼ turn. Opening valve further may
cause it to disengage from pump body, which will disable manual pump.
2. Refer to
Figure 3-22
. Remove 5/8” screw from the front of 3” long pin retainment weldment.
