MAINTENANCE
S-SERIES PRIVATE USE SERVICE MANUAL
SEPTEMBER 2020
3- 10
32DSW02.F
FIGURE 3-17
FIGURE 3-18
3. Refer to
Figure 3-19
. Slide gas spring inward then lift and remove from baseplate.
FIGURE 3-19
4. Remove the screw and collar that attaches the cable to baseplate and retain for installation.
5. Remove cable from baseplate. Discard old cable.
NOTE:
Do not reuse old cable. Use Cable (P/N 35233) provided in Kit (P/N 36998).
6. Install cable (P/N 35233) and secure with existing screw and collar, retained from step12, Section E.
NOTE:
Do not reuse old cable. Use Cable (P/N 35233) provided in Kit (P/N 36998).
7. Refer to
Figure 3-20
. Install clevis (P/N 35232) onto gas spring (P/N 39368).
RSB0000500
GAS SP R ING (P /N 39368 )
LOCK NU T (P /N 14-08 -304 )
P ULLEY SHIELD (P/N 35958 )
CLEVIS (P/N 35232 )
G ROO VE D BEA RIN G (P/N VS -AH -06 )
1/4-20 X 7/8" SC REW (P /N 39 370 )
THREADED END
FIGURE 3-20
8. Refer to
Figure 3-20
. Assemble grooved bearing (P/N VS-AH-06), pulley shield (P/N 35958) and
attaching parts onto clevis (P/N 35232). Do not tighten.
NOTE:
Do not tighten ¼-20 screw onto pulley shield with lock nut until cable has been routed onto grooved
bearing.
