S-SERIES PRIVATE USE SERVICE MANUAL
INSTALLATION
SEPTEMBER 2020
2 - 12
32DSW02.F
5.
WHEELCHAIR LOCATING PLATES ADJUSTMENT
Adjustment for how far back the wheelchair locating plates will vary according to the mobility aid equipement that
is used as well as the limitations of the wheelchair lift platform.
CAUTION!
Adjusting the wheelchair locating plates beyond the limitations of the platform will interfere with
lift operation and may endanger wheelchair occupant.
a. Refer to
Figure 2-14
. Remove and retain two washers and two nuts from bottom side of platform to ad-
just wheelchair locating plates.
b. Lift and place wheelchair locating plates according to mobility aid that will be utilized. Do not install
wheelchair locating plates close to bridgeplate.
c. Reinstall two washers and two nuts under platform to secure each wheelchair locating plate.
6.
PLATFORM PRESSURE SWITCH CHECK AND ADJUSTMENT
Correct adjustment of this pressure switch will prevent platform from folding into vehicle when there is a load of 50
lbs, or more, on the platform.
a. Refer to
Figure 2-15
. Deploy and lower platform to ground. Place a 50 lb. load (no larger than
VERTICAL LINK
APPLY 50 LB. LOAD
FIGURE 2-15: PRESSURE SWITCH TEST AT FLOOR LEVEL
D O N O
T A D J U S
T L O CAT IN G
P LAT E S C L O S E
TO
B R ID G E P L
AT E
D O N O
T A D J U S
T L O CAT IN G
P LAT E S C L O S E
TO
B R ID G E P L
AT E
WA S H E R ( X 2 )
N UT ( X 2 )
B R ID G E P L
AT E
FIGURE 2-14: WHEELCHAIR LOCATING PLATE ADJUSTMENT
