S-SERIES PRIVATE USE SERVICE MANUAL
INSTALLATION
SEPTEMBER 2020
2 - 8
32DSW02.F
4.
INTERLOCK DEVICE INSTALLATION
The supplied interlock device must be installed to prevent operation of the lift or vehicle when it is unsafe to do so.
The Slide-Away lift provides an electrical interlock signal to the vehicle that prevents movement of the vehicle un-
less the platform is fully stowed. The interlock control also supplies power to the lift only when the vehicle parking
brake is set and the transmission is in PARK.
NOTE:
An 8-amp circuit breaker is located within the lift as a circuit protection device. The circuit interface used
by the installer must be capable of carrying an additional 8 amps of continuous current.
Refer to
Figure 2-8
. The interlock installation kit provides a display panel for mounting on the vehicle dashboard.
The figure shows an LED display panel. The Lift Power LED lights green when the vehicle transmission is in
PARK and the parking brake is set. While the LED is green the lift is lowered and the platform can be deployed.
The Not Stowed LED lights red when the platform is not fully stowed into the vehicle. While the LED is red the
transmission cannot be shifted out of PARK.
NOT STOWED
LIFT POWER
(GREEN)
(RED)
FIGURE 2-8: INSTERLOCK DISPLAY PANEL
The installer must verify that none of the original equipment circuit breakers, fuses, or solenoids are bypassed,
removed, or altered. Be sure that no wires are left frayed or hanging loose after installation of the interlock de-
vice. If you have any questions concerning the proper installation of this interlock device, please contact our
Product Support department.
C. FINAL ADJUSTMENTS
1.
LIMIT SWITCH ADJUSTMENT
Refer to
Figures 2-9, 2-10,
and the following procedure.
NOTE:
To avoid operational “dead-spots”, adjust DEPLOY CUTOFF SWITCH before UP CUTOFF SWITCH.
NOTE:
When loosening adjustment screws, apply enough pressure to screw to move block instead of screw.
(The block might stick if insufficient pressure is applied to screw.)
FIGURE 2-9: LIMIT SWITCH ADJUSTMENT DIAGRAM
SWITCH
DEPLOY CUTOFF
ADJUSTMENT
FOLD CUTOFF
UP CUTOFF
SCREW
DEPLOY CUTOFF
LOWER
UP CUTOFF SWITCH
ACTUATOR
CAM
FOLD CUTOFF
ADJUSTMENT
SCREW
CAM LOBE
SWITCH
